During this period you will be able to hear the pump running.
Maxima maytag washer door locked.
Reconnect power to washer plug in.
The washer will go into a hold and drain routine for 8 minutes.
The door is also locked.
The door lock led light will blink.
When using one of these cycles the door will remain locked until the cancel button is pushed.
The door may immediately unlock.
How long has this been going on with your maytag washer.
Wait approximately 2 minutes for control to reset.
Our maytag washer is displaying e01 and f09 codes.
Is there anything that i can do to clear the codes and unlock the front load door.
If not call for service.
I noticed that my maytag maxim front load washer was flashing door lock and error code f6e1 i think along with annoying chimes or buzzing.
Run a drain and spin cycle.
The door should unlock after this is complete.
Once the washer door is closed the washer can begin operating.
It stopped right after it dispensed the detergent and i ve tried all of the not so helpful repair advise on the maytag website and i still can t get it unlocked.
After 8 minutes the door will unlock.
Wait approximately 2 minutes for control to reset.
Now you can reach down in from below the top of the machine down to the door latch.
Door lock can fail either mechanically or electrically.
Press the power button and the washer will start a drain routine which takes approximately 8 to 10 minutes during which time the pump will run continuously.
Pull down on this tab and then open the door.
The door should unlock after 60 seconds.
The control will not accept any input during this time.
The door lock secures the washer door shut during operation.
Unplug the washer then pull the top panel of the washer straight back up and off.
There is a pull tab at the bottom of the door latch which will manually unlock the door.
If the washer has an f8 e1 error or lo fl error the door will be locked and the control will be unresponsive.
Our maytag maxima steam washer has a flashing yellow light next to door locked the door won t open and the machined cannot be turned on.
If the washer does not unlock at the end of a wash cycle unplug the appliance or disconnect power.
If the door lock is defective the washer door will not latch properly.