When using one of these cycles the door will remain locked until the cancel button is pushed.
Maytag neptune front load washer door locked.
After 8 minutes the door will unlock.
Nothing else will appear to be happening with the machine during this time.
If the washer has an f8 e1 error or lo fl error the door will be locked and the control will be unresponsive.
The door should unlock after this is complete.
You may also see an f8 e1 error code.
The washer will go into a hold and drain routine for 8 minutes.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
If the washer was powered on before being connected to water the door may be locked and it may go into a drain mode.
Run a drain and spin cycle.
If the washer does not unlock at the end of a wash cycle unplug the appliance or disconnect power.
This is a page about unlocking the door on a maytag front load washer.
The door should unlock after 60 seconds.
If not call for service.
When the control is locked the cycles cannot be started or changed.
Were you using a fresh hold cycle available on some models.
Reconnect power to washer plug in.
Wait approximately 2 minutes for control to reset.
I am unable to start the wash cycle or open read more.
It flashed d o beeps and also flashed f l.
Wait approximately 2 minutes for control to reset.
The door lock led light will blink.
Press this icon to lock the controls.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
Once under tools tap the control lock icon.
During this period you will be able to hear the pump running.
I have opened up the soap dispenser on the left side of the washer to find the read more.
Swipe up to unlock.