Repeat until water begins to flow.
Maytag french door refrigerator ice maker not working.
If the ice maker s water supply is not connected to water supply line turn the ice maker off.
If the ice maker is on but disconnected to water supply line the following could happen.
If the door switch fails the dispenser will not turn on.
A clogged or incorrectly installed water filter will reduce the water flow to the ice maker and dispenser which will result in small ice cubes low ice production or decreased water flow.
Fix a maytag french door refrigerator that has this following issues.
Test the ice maker dispenser about one hour after removing all the jammed ice cubes.
Check that the ice cubes are not jammed in the chute.
Not producing ice at.
Freezer temperature is above 10 degrees f 12c if the freezer temperature is above 10 degrees fahrenheit 12c the ice maker will not produce ice cubes efficiently.
Unjam the ice maker chute.
Next fill up the icemaker with a cup of water and wait 24 hours to see if it cycles and dumps the ice.
If the control board is faulty it may stop supplying power to the entire dispenser system.
If the door switch does not have continuity when activated replace it.
To determine if the door switch is defective use a multimeter to test it for continuity.
Flushing the water system forces air from the water line after the refrigerator has been installed or the water filter has been replaced.
Use a sturdy container to press and hold the water dispenser pad for 5 seconds then release it for 5 seconds.
Discard any ice in the area that is jamming up the chute.
Verify that the ice maker is turned on.
The freezer temperature should be set between 0 and 5 degrees fahrenheit 18 to 15c for the ice maker to work properly.
Maytag refrigerator ice dispenser not working 01 dispenser control board the dispenser control board governs most of the functions of the dispenser system.
The door switch turns off the ice and water dispenser when the refrigerator door is open.
If the refrigerator has a water dispenser check for a problem with the filter by doing the following.
Check for clumping near the ice ejector arm or auger.
A refrigerator section may to be too cold.